Skip to content
PLATESOFTWARE

Road plates

Printing a front and rear pair

Sending both faces as one job, on one printer or two.

← All guides3 min read

One printer

  1. Check both faces with the Front and Rear preview buttons.
  2. Set Copies in the bottom bar.
  3. Tick Print pair.
  4. Use Print preview to confirm placement, then print. The two faces are sent as sequential jobs.
The bottom bar of the road workspace showing plate dimensions, the selected printer, plate checks, the evidence tick box, copy quantity and the print button.
The bottom bar, where the job is sent

Two printers

If fronts and rears go to different machines, assign a saved printer profile to each face in Print setup. Pair printing then sends each face to the correct printer without you switching anything.

Reprinting

Open Production to see what you have printed and send it again. You do not need to rebuild the design to reprint a plate.

Did this not answer your question? Email support@platesoftware.co.uk and tell us what you were trying to do.